...
Check this box to enable plot layout
Plot Layout > Enable Stand Buffer / Plot Layout > Stand Boundary Buffer
if a value greater than 0 is used here, If stand boundary buffer is desired, check the checkbox to enable this functionality and then supply a Stand Boundary Buffer value (in feet). When used the stand boundary will be buffered inward by the selected number of feet. This will , which prevent plots from being created along the stand boundary.
...
Select a stand for plot creation – Once the settings have been configured, begin plot creation by using the edit tool on the Stand layer and selecting an existing stand. Then select the plot layout icon (9 points, upper right of toolbar).
...
Version 4.
...
4.
...
0+
Enhancements were made to Plot Layout at version 4.3.61. These enhancements include:
...
To see the new plot creation capabilities, watch this YouTube video: https://youtu.be/ceYMh2wDWGk or this
Versions pre-4.
...
4.
...
0
Review the area, minimum and maximum plots, plot density and target plot count information. The target plot indicates the number of plots that the tool will create. If this number does not seem right, edit it within the window by pressing the back cursor and type in the number of plots you prefer. Below is an example which shows it originaly had 47 plots but changed to 10 plots Press ‘CREATE PLOTS’. The tool will generate candidate plots and return to the main map display to enable review and acceptance (or rejection) of the candidate plots.
...
When the candidate plots are displayed, review them for plot count, placement, etc. Tap the green checkbox to accept and the red X to reject. To re-run the tool, tap the Stand again, and repeat the process described above.
Deleting Plots
Version 4.
...
4.
...
+
At version 4.3.61 there is a batch delete plot tool which can be used to delete all plots within a stand if no plots have been measured (not plots have any trees). This tool is accessed from the Plots button (icon is grid of 9 points) on the Stand feature. When the options open, select Delete Plots. This action will delete all plots without asking for confirmation, but will only proceed if there are no trees collected for any plot within the stand. If even a single plot has a single tree this tool cannot be used. This restriction is in place to prevent accidental deletion of plots.
...
It is still possible to delete individual plots using standard feature editing workflow, see below.
Pre-4.
...
4.
...
0
To delete a single plot in MobileMap, select the edit tool, tap on the plot you would like to delete, then select the delete option (trash can icon). You will be asked to confirm deletion.
...